Determination of Aldehydes and Ketones in Fuel Ethanol by High-Performance Liquid Chromatography with Electrochemical Detection

A new methodology was developed for analysis of aldehydes and ketones in fuel ethanol by high-performance liquid chromatography (HPLC) coupled to electrochemical detection. The electrochemical oxidation of 5-hydroxymethylfurfural, 2-furfuraldehyde, butyraldehyde, acetone and methyl ethyl ketone derivatized with 2,4-dinitrophenylhydrazine (DNPH) at glassy carbon electrode present a well defined wave at +0.94 V; +0.99 V; +1.29 V; +1.15 V and +1.18 V, respectively which are the basis for its determination on electrochemical detector. The carbonyl compounds derivatized were separated by a reverse-phase column under isocratic conditions with a mobile phase containing a binary mixture of methanol / LiClO_4(aq) at a concentration of 1.0 × 10⁻³ mol L⁻¹ (80:20 v/v) and a flow-rate of 1.1mL min⁻¹ . The optimum potential for the electrochemical detection of aldehydes-DNPH and ketones-DNPH was +1.0 V vs. Ag/AgCl. The analytical curve of aldehydes-DNPH and ketones-DNPH presented linearity over the range 5.0 to 400.0 ng mL⁻¹, with detection limits of 1.7 to 2.0 ng mL⁻¹ and quantification limits from 5.0 to 6.2 ng mL⁻¹, using injection volume of 20 μL. The proposed methodology was simple, low time-consuming (15 min/analysis) and presented analytical recovery higher than 95%.     

吸热型碳氢燃料在银、镧改性ZSM-5分子筛上的裂解研究

为提高吸热型碳氢燃料的吸热能效，对HZSM－5分子筛进行了La^3 、Ag^ 离子交换改性，考察了吸热型碳氢燃料NNJ－150在HZSM－5及改性ZSM－5分子筛催化剂上的裂解情况。结果表明，La^3 、Ag^ 离子交换改性催化剂提高了NNJ－150的裂解气中低碳烯烃的选择性（500℃,81.63%)，并且改性催化剂和未改性催化剂的活性在35min内均未随进样时间下降，转化率也未降低（500℃,HZSM-5,64.62%;LaZSM-5,65.71%；AgZSM-5,68.75%)。实验结果表明，双金属离子改性可为今后研究的方向。     

PEMFC催化剂的研究：自制抗CO中毒Pt-Ru/C电催化剂的性质

用胶体法制备了抗CO中毒PEMFC阳极Pt-Ru/C电催化剂（标记为THYT－2）,对 比研究了THYT－2与Johnson Matthey (JM)公司同类品牌Pt-Ru/C催化剂的电化学及 其它物理化学性能。结果表明,THYT－2电催化剂在甲醇燃料电池和CO／H_2（Φ_ (CO) = 1 * 10~(-4)）的氢氧燃料电池中的电催化行为与JM催化剂相当,但THYT－ 2在低浓度CO氢气燃料中的电池性能更好。两种催化剂的其它物理化学性质具有类 似性：XPS分析结果表明THYT－2和JM催化剂 中都有三种不同价态的Pt存在：即金 属态Pt(0)、氧化态Pt(II)和Pt(IV)。HRTEM测试结果表明两种催化剂的粒径处在2 ～3 mn左右,这可能是它们拥有良好电化学性能的主要原因之一。本文还对催化剂 中Pt与Ru组分的分布和相互作用进行了讨论,提出了改进Pt-Ru/C电催化剂的思路 。     

Mg／Mgl．8La0．2Ni纳米复合材料的吸放氢性能研究

应用高能球磨法制备Mg-x％Mg1.8La0.2Ni（x=10、20和30）纳米复合储氢材料．X射线衍射（XRD）、透射电镜（TEM）和选区电子衍射（SAED）测试表明，该复合材料具有纳米晶和非晶态混合结构的性质，吸氢温度降低，较好的吸放氢动力学性能，在423K，2．5MPa氢压的条件下，50s内即可达到最大吸氢量．     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅰ. 催化剂焙烧温度的影响

 以类层柱CuZnAl水滑石为前体,经不同温度焙烧制备了一系列甲醇水蒸气重整制氢催化剂. 在250 ℃、 水/甲醇比1.3和重时空速2.5 h-1下的反应结果表明, 600 ℃焙烧的催化剂具有优异的活性和稳定性,而≤500 ℃和≥700 ℃焙烧后的催化剂活性较差. 热重、 X射线衍射、 傅里叶变换红外光谱和程序升温还原分析结果表明, 600 ℃焙烧时水滑石分解较为完全,析出纳米CuO粒子的同时伴生CuAl2O4尖晶石相,进而在反应过程中对金属Cu纳米粒子和ZnO起到良好的隔离和稳定作用. 焙烧温度≥700 ℃时CuO纳米粒子发生二次团聚,同时CuAl2O4尖晶石相大量生成,造成催化活性位减少,活性较低; 而焙烧温度≤500 ℃时水滑石分解不完全,生成 (Cu,Zn)AlxOy(CO3)z复合物且无尖晶石相伴生,造成反应中金属Cu纳米粒子和ZnO聚集,导致催化剂活性较低.     

Investigation of the electrocatalytic oxidation of formate and ethanol at platinum black under microbial fuel cell conditions

In this communication, we discuss the electro-oxidation of the fermentation products formate and ethanol at platinum black modified electrodes under microbial fuel cell conditions, i.e., at neutral pH, room temperature, and in microbial culture solutions. The electrocatalytic oxidation was studied using cyclic voltammetry, chronoamperometry, and potentiostatic coulometry. Current densities up to 6 mA cm⁻² at 0.2 V oxidation potential and 97% coulombic efficiency were observed for the electro-oxidation of 100 mM solutions of formate in pH 7 buffer solution. Electrode deactivation could be successfully prevented using an oxidative potential reactivation procedure. Polymer coating, however, fully stopped the formate oxidation. As expected, the electro-oxidation of ethanol was less efficient—with a limiting current density being 600 μA cm⁻².Dedicated to Professor Dr. Alan M. Bond on the occasion of this 60th birthday.     

生物质能源的开发与利用

本文概述了生物质能源的特征以及发展生物质能源的意义,综述了国内外生物质能源开发与利用的现状,简介了中国石油天然气股份有限公司生物质能源的发展思路、部署及工作进展.中国石油天然气股份有限公司生物质能源发展策略重点放在发展生物柴油和燃料乙醇.本文结合公司生物质能源长期发展战略以及实际工作开展情况分别从生物柴油、燃料乙醇两个方面详细探讨了所面临的生物质能源化工关键技术的需求,并提出相关发展建议.     

磺化酚酞型聚醚砜膜的制备及其阻醇和质子导电性能

直接甲醇燃料电池 (Directmethanolfuelcell,DMFC)以高效、清洁和燃料储运方便等优点适宜于作为各种用途的可移动动力源 ,成为 2 0世纪 90年代以来研究与开发的热点[1,2 ] .目前 ,这种电池的研究难点主要集中在催化剂不稳定和质子交换膜透醇上 .一张好的DMFC膜不但要可传递质子、绝缘电子 ,还应具有良好的阻醇性能 .如果膜的阻醇性能不好 ,甲醇会穿过膜到达阴极 ,与氧直接反应而不产生电流 ,不但造成燃料的浪费 ,同时也影响阴极的正常反应 ,使电池效率下降[3 ] .目前广泛应用于燃料电池中的Nafion 系列膜是由美国DuPont公司生产的一种…     

La0.8Sr0.2Ga0.8Mg0.2O2.8的电化学性质及其在SOFC中的应用

采用凝胶浇注法制备具有较高氧离子电导率的固体电解质La0.8Sr0.2Ga0.8Mg0.2O2.8粉料.X射线衍射结果表明,于1400℃焙烧后即形成了钙钛矿结构,无杂相存在.探讨了粉料压制坯体的致密化和导电性能在1450℃下与烧结时间的关系,发现烧结时间为18h时其相对密度达98.3%,而在24h的情况下,样品具有最佳的氧离子导电性.采用Ni-Ce0.8Gd0.2O1.9作为阳极,La0.8Sr0.2Ga0.6Ni0.4O2.7作为阴极,组装了平板型固体氧化物燃料电池(SOFC).阳极和阴极分别通入含3%H2O的氢气和空气,750℃时的开路电压为1.04V,最大输出功率密度(P)达252mW/cm2(U=0.48V,J=525mA/cm2).     

Effect of polarization on the electrode behavior and microstructure of (La,Sr)MnO<Subscript>3</Subscript> electrodes of solid oxide fuel cells

The electrode behavior and microstructure of freshly prepared (La_0.8Sr_0.2)_0.9MnO₃ (LSM) electrodes were investigated under various polarization conditions. The original, large agglomerates in freshly prepared LSM electrodes were broken down into sphere-shaped grains when exposed to cathodic or anodic current passage of 200 mA cm^–2 at 800 °C in air for 3 h. Microstructural changes under cathodic polarization could be related to the pronounced diffusion and migration of oxygen vacancies and Mn ions on the LSM surface and lattice expansion, while lattice shrinkage under oxidation conditions most likely contributes to the structural changes under anodic polarization. Such morphological changes were irreversible and were found to be beneficial to the performance of freshly prepared LSM electrodes. Freshly prepared LSM electrodes behaved very differently with respect to the cathodic and anodic current passage treatment.